Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
container, the display will show its net weight. When the container is removed,
the display will show a negative value and Tare symbol will disappear.
STAND-BY FUNCTION
After 40 seconds of no use, the balance will go into power saving mode
(stand-by) and the display will show "0".
STATE OF BATTERY INDICATORS
"High" means that voltage is higher than 6.3V.
"Mid" means that voltage is between 6V and 6.3V.
"Low" means that voltage is lower to 6V.
BATTERY RECHARGING
The internal rechargeable battery is off. When the display shows "-Lo-", turn
off the balance and recharge it immediatelly. The time needed to charge the
battery at 100% is 12 hours.
PARAMETERS SETUP
Press the key
pressing the key
\ A-oFF \ FILt \ Zero \ Buzzer \ d \ on-ra \ d-dp.
Auto-zero range setting
Press the
"range", press again the key
the key
10
for 3 seconds, the display will show "range", continuously
, will be displayed the following functions: range\ Units
key for 3 seconds until the displays shows the message
, the display will show the current zero range, press the key
until "2Ero" message is displayed. Press
Publicité
Table des Matières
