Gram K1 Manuel D'utilisation page 11

LF1; Calibration menu
o Press the
(zero calibration value), press the
value. Use the
increase the digit value. Once entered the value, place the calibration weight on
the weighing pan and then press
again the
immediately the calibration will be completed.
LF2; Parameters setup menu
o Press the
be displayed.
o Press the
o Display will show:
This menu, should only be modified for special configurations.
If necessary to modify:
o A : Metrical system
o B : American system
o C : Other units
o D : Pieces
o E : Dual range
o F : Calibration unit
- Press the
o Select the maximal capacity of the balance, taking in mind the decimals, for
exemple for 150 kg -20g
- Press the
To select the decimal point, press the
the
key to enter to Calibration menu, the display will show CALZ
key to move a digit to the right and use the
to confirm. A series of dashed will be displayed - - - - - - and
key to enter to Parameters setup menu, the internal counts will
to continue.
1 0 0 0 0 1
A B C D E F
key to continue
 015000 (The last two zeros respecte the decimal points 150.00)
key to confirm
to confirm.
key to modify the calibration weight
. The value will flash continuously, press
0 : None 1 : kg
0 : None 1 : lb
0 : None 1 : TW Kg 2 :HK Kg
0 : Off 1 : On
0 : Off 1 : MULTI INTERVAL 2 : MULTIRANGE
1 : European 2 : American
key to view the different options and
2 : T 3 : g
2 : lb oz
3 : VISS
key to
11