Assembly - Husqvarna 525LS Mark II Manuel D'utilisation

• Always stop the engine and let it cool off for a few
minutes before you refuel.
• Open the fuel cap slowly so that any excess
pressure is released gently when you refuel.
• Tighten the fuel cap carefully after you refueled.
• Clean the area around the fuel cap. Contamination in
the tank can cause operating problems.
• Always move the product 3m (10ft) or further from
the refuelling area and source before starting.
Safety instructions for maintenance
WARNING:
before you do any work on the cutting
attachment. The cutting attachment
continues to rotate even after the throttle
has been released. Ensure that the cutting
attachment has stopped completely and
Introduction
WARNING:
product, you must read and understand the
safety chapter.
WARNING:
cable from the spark plug before you
assemble the product.
To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrow symbols.
2. Put the bracket on the opposite side and put the 2
screws into the holes on the loop handle.
3. Adjust the loop handle to a comfortable position.
4. Tighten the screws.
To assemble and disassemble the cutting
attachment guard and trimmer head
1. Attach the correct cutting attachment guard (A) for
the trimmer head. Refer to
10
Always stop the engine

Assembly

Before you assemble the
Remove the spark plug
Accessories on page 21 .
disconnect the spark plug before you start to
work on it.
WARNING:
may increase the risk of accidents.
WARNING:
cord is wound tightly and evenly around the
drum, otherwise the product will generate
harmful vibration.
• Only use cutting attachments with the guards we
recommend. Refer to
• Your warranty may not cover damage or liability
caused by the use of non-authorized accessories or
replacement parts.
2. Put the cutting attachment guard onto the fitting on
the shaft.
3. Attach the cutting attachment guard with the screws
(B).
4. Install the drive disc (C) on the output shaft.
5. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
6. Put the locking pin (D) in the hole to lock the shaft.
B
7. Turn the cutting equipment (E) in the opposite
direction from which the cutting equipment rotates.
E
A faulty cutting attachment
Make sure that the trimmer
Accessories on page 21 .
C
A
E
1560 - 002 - 22.06.2021
D