Assembly; Fitting The Loop Handle; Fitting The Trimmer Guard And Trimmer Head - Husqvarna 124L Manuel D'utilisation

NOTE:
Make sure unit is assembled cor-
rectly as shown in this manual.

Fitting the loop handle

S Position the handle on the shaft. Note
that the handle must be mounted be-
tween the two arrows on the shaft.
S Fit the screw, securing plate and wing
nut as shown in the diagram.
S Tighten the wing nut.
115374527 Rev. 5 5/15/12

ASSEMBLY

itting the trimmer guard and
F
trimmer head
S Fit the correct trimmer guard (A) for use
with the trimmer head. Hook the trimmer
guard/combination guard onto the fitting on
the shaft and secure with the wing nut (B).
A
S Turn the shaft until one of the holes in the
dust cup aligns with the corresponding
hole in the gear housing.
S Insert a small screwdriver (C) into the
aligned holes to lock the shaft.
C
S Screw on the trimmer head (D) in the op-
posite direction to the direction of rota-
tion.
D
S To dismantle, follow the instructions in
the reverse order.
B
English--- 12