Safety Instructions - AYA ATV4F/1 Instructions D'utilisation

SAFETY INSTRUCTIONS

Table des matieres
Ensure there is a Power Power outlet nearby(behind the unit)
A dedicated power circuit is recommended for the unit .
Additional electrical appliances on the same circuit may exceed the
current(amperage)rating for that circuit.If after the installation of your unit.the
circuit breaker trips or the fuse fails on a repeated basis,then a dedicated
circuit will likely be required.
!The appliance must be installed only by a qualified person in compliance with
the instructions provided.Incorrect installation may cause harm to
persons,animals or may damage property.
The manufacturer declines all responsibility for improper installation which
may harm persons and animals and damage property.
The power supply to the appliance must be cut off before any adjustments or
maintenance work is done on it.
Your Hob is a classified electrical appliance.As with any electrical appliance
and particuly with electric heaters,basic precautions must be followed in order
to reduce the risk of fire,burns,electrical shocks or other serious injuries or
death.
The appliance becomes hot during operation.Take care not to touch the hot
parts the electric Hob.
Always keep children away from the hob. While in operation direct contact with
the hob may cause burns!
Ensure that small items of household equipment,including connection
leads,do not touch the hob as the insulation material of this equipment is
usually not resistant to high temperatures.
Do not use the hob in the event of a technical fault.Any faults must be
fixed by an appropriately qualified and authorised person.
In the event of any incident caused by a technical fault,disconnect the
power and report the fault to the service centre to be repaired.
The rules and provisions contained in this instruction manual should be
strictly observed. Do not allow anybody who is not familiar with the
contents of this instruction manual to operate the hob.
Cabinets with a veneer exterior must be assembled with glues which can
withstand temperature of up to 100℃.
11