External Connections - pico Technology PicoScope 6000E Série Guide De Démarrage Rapide

Quick Start Guide
Exceeding the voltage rating on any cable, connector or accessory can cause permanent damage to the
oscilloscope and other connected equipment.
2.3 Grounding
The oscilloscope's ground connection through the USB cable is for measurement purposes only. The oscilloscope
does not have a protective safety ground.
Never connect the ground input (chassis) to any electrical power source. To prevent personal injury or death, use a
voltmeter to check that there is no significant AC or DC voltage between the oscilloscope ground and the point to
which you intend to connect it.
Applying a voltage to the ground input is likely to cause permanent damage to the oscilloscope, the attached
computer, and other equipment.
To prevent measurement errors caused by poor grounding, always use the high-quality USB cable supplied with the
oscilloscope.

2.4 External connections

To prevent injury or death, use only the power cord and adaptor supplied with the product. These are approved for
the voltage and plug configuration in your country.
External DC power supply
PicoScope 6824E
PicoScope 6424E
PicoScope 6804E
PicoScope 6404E
PicoScope 6403E
2.5 Environment
To prevent injury or death, do not use in wet or damp conditions, or near explosive gas or vapor.
To prevent damage, always use and store your oscilloscope in appropriate environments.
DO338-4
CAUTION
WARNING
CAUTION
WARNING
Voltage (V)
12
12
12
12
12
WARNING
CAUTION
Copyright © 2020 Pico Technology Ltd. All rights reserved.
PicoScope 6000E Series oscilloscopes
Current (A pk)
Oscilloscope only
5
4.5
4.5
4
3.5
Oscilloscope + powered
accessories
7
6.5
6.5
6
5.5
5