Other Operations - Sony CDP-CE575 Mode D'emploi

Playing the CD (continued)
Repeat Play Operations
You can play the CD tracks repeatedly in any
play modes.
To activate the Repeat Play function, press
REPEAT until "REPEAT' appears in the
display.
To
Repeat only one track
Cancel Repeat Play
When you are in the Repeat Play function, the
player repeats the tracks as follows:
When the disc is
played in
Continuous Play
(ALL DISCS)
Continuous Play
(1 DISC)
Shuffle Play
(ALL DISCS)
Shuffle Play
(1 DISC)
Programme Play
(page 13)

Other Operations

To
Stop playback
Pause
Select a track
10
GB
Press REPEAT
Until "REPEAT 1" appears
while playing the track you
want to repeat.
Until "REPEAT" or
"REPEAT1" disappears.
The player repeats
All the tracks on all discs
All the tracks on the current
disc
All the tracks on all discs in
random orders
All the tracks on the current
disc in random orders
The same programme
Do this
Press x.
Press X. Press X again or
H to resume play.
During play or pause, turn
lAMSL clockwise
(to go forward) or
counterclockwise (to go
backward) (or press >(
to go forward) or . (to
go backward) on the
remote).
To
Select a track directly
Go to the next disc
Select a disc directly
Find a point in a track
By scanning each track
for 10 seconds
(Music Scan)
Play tracks in random
order
Remove the CD
Adjust the volume
* When you directly locate a track numbered over 10,
press >10 first, then the corresponding number
buttons. To enter "0," use button 10.
Example: To play track number 30
Press >10 first, then 3 and 10.
Tips
• You can adjust the analog output level with the
ANALOG OUT LEVEL +/– on the remote (page
6).
• You can adjust the headphones volume on the
remote. To adjust the volume, connect the
headphones to the PHONES jack and adjust the
volume with the ANALOG OUT LEVEL +/– on
the remote.
• If there is no CD in the player, "–NO DISC–"
appears in the display.
Notes
• If "OVER" appears in the display, the disc has
reached the end while you were pressing M. Press
m or turn lAMSL counterclockwise to go
back.
• If you press ANALOG OUT LEVEL +/– while
recording, the recording level will change even
when it is preset on the tape deck, etc.
Do this
Press the number button on
the remote.*
Press DISC SKIP.
Press DISC 1 – 5.
When using the remote,
follow the procedure below.
1 Press DISC.
2 Press the number button
of the disc.
3 Press ENTER.
Press and hold M or m
during playback, and
release at the desired point.
Press MUSIC SCAN. When
you find the track you want,
press H to start playing
the track. Each time you
press MUSIC SCAN, the
playing time changes
cyclically.
Press SHUFFLE until
"SHUFFLE" appears in the
display.
Press AOPEN/CLOSE.
Press ANALOG OUT
LEVEL +/– on the remote.