ECOFOREST Kerala-1 Manuel D'installation Et Maintenance page 43

This drawing shows the Eco II Insert stove, and the only thing that changes about others models is the layout
of the extractor.

Gas outlet direction.

Gas outlet extractor.

Ceramic fiber joint (replace).
When reassembling the exhaust it is COMPULSORY to replace the exhaust joint with a new one as you run
the risk of gas entering in our home.
5.11. Dismantling and cleaning of gas outlet pipes.
When the gas outlet pipes are reinstalled, we must ensure that these are properly sealed. If the pipe has
watertight joints, we must verify their correct condition and replace them if they were faulty, going as far as
to test the watertightness using silicone resistant to high temperatures.
5.12. Cleaning the dirt which may be accumulated inside the stove, accessing through the back.
5.13. Review the glass door joints.
Review in detail any imperfections which may cause an air inlet. Replace them if necessary.
5.14. Lubricate the screws and the glass door handle.
5.15. Lubrication of the brass tips of the endless shaft's upper and lower parts with lubricant oil; a small quantity is
enough for all the season. This operation is ONLY recommended in case of noisy.
You get access to the lower tip from inside the hopper, you will see it clearly after removing all pellets.
In order to reach the upper tip, you have to dismantle the endless screw from the back side of the stove; this
shall be necessary only in case of noise as it has been lubricated at manufacturing, with a high quality
lubricant sufficient for many years.

Reducing motor of endless.

Brass fitting and lubrication point.
IMPORTANT: After cleaning or fixing, make sure the stove operates correctly. Once you turn the stove off or
during the seasons when you do not use it, disconnect the stove to avoid electronic damages.
It consists in controlling the combustion air inlet and gas outlet; make sure nothing prevents normal
circulation (e.g. bird nests). The gas outlet must also be inspected for possible water infiltrations.
In addition, it is recommended to clean the base of floor of the stove, the back side of the stove that you
reach through the back grid or lateral doors, in order to take eventual dust away that might have stacked during
summer time.
CHECKING AT BEGINNING OF SEASON.
42
Drawing 30
Drawing 31