ECOFOREST Kerala-1 Manuel D'installation Et Maintenance page 36


Leg.

Front and rear strengtheners.

Side strengtheners.

Stove base.
KEYBOARD CONECTION, POWER WIRING AND ROOM THERMOSTAT.
The first thing to do is locate the keyboard in the fireplace inside a box, with the remote control, room
thermostat and power wiring.
We must adjust the screws that secure the bracket to the stove (
keyboard connection band (

back of the keyboard ( ). Connection has only one position.
For the Ecoaire and Eco II embedded model stoves, the keyboard support is located in the trim cover frame,
as can be seen in Drawing 12 (Eco II). As the Córdoba model stove has been devised for installation in a decoration
created expressly for this purpose, a space of 127x41mm must be left free to position the keyboard. The flat tape is
directly connected to the C.P.U., this must be stretched and the same connection steps as performed with the stove
model must be followed, taking into account during the installation of the Córdoba, the length of the tape and the
room for manoeuvre available which allows for us to perform maintenance tasks.
The room sensor and the power wire are connected at the rear of the stove of Ecoaire and Eco insert as
shown in drawing 11 (Ecoaire) and in the right side in Eco II and Kerala models as shown in drawing 12 (Eco II). You
will know that the stove recognize it because the room temperature will be shown in the control panel. If you
connect a thermostat or contact instead of displaying the room temperature it will be shown ( · ) indicating this that
there is something connected in the communication port.

Screws for keyboard support.

Support with mounted keyboard.

Keyboard's connection band and C.P.U.

Back side of keyboard.

Thermostat connection.

Power connection ~230/240V - 50Hz.

Thermostat.

), which is situated at the back side attached with adhesive tape and connect it to the

) as shown in drawing 11. Connect the
35
Drawing 10
Drawing 11