Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Stainless steel hose clamp.
T of 135° with outlet.
Elbow of 45°.
Wooden ground.
Non flammable floor protection.
Stainless steel flexible tube.
Rigid flexible pole adapter.
Minimum 200mm.
It must exceed roof height by 1 metre.
If the tube over 4 m in length, the next larger
size will be used.
4.26. Installing a fitted stove in a brickwork chimney can be done using flexible piping in its entirety, as indicated in
drawing 9. We must take special care when sealing the chimney and gas venting to avoid gas blowing back
during storms.
Stainless steel hose clamp.
T of 135° with outlet.
Wooden ground.
Non flammable floor protection.
Stainless steel flexible tube.
Rigid flexible pole adapter.
Anti blow-back seal.
Minimum 200mm.
It must exceed roof height by 1 metre.
If the tube over 4 m in length, the next larger
size will be used.
When installing a flexible tube for gas outlet, be careful that this is not in contact or close to the circuit board
or combustible material.
PLACING LEGS ON THE CÓRDOBA GLASS AND CÓRDOBA MODELS (OPTIONAL).
Join the 4 legs to form a rectangle with side and front strengtheners as indicated in Drawing 10.
Open the stove guides in such a way that we can access the fixing points for the legs at the base of the stove.
The assembly order for the stove resting above its legs will depend on the installer's needs, being able to fix
the legs into place and perform the base assembly later; or either assemble the entire stove and legs and later
position this and fix the legs to the floor. It is compulsory to screw the legs to the floor.
34
Drawing 8
Drawing 9
Publicité
Table des Matières
