Operation - Venmar C180 Série Directives D'installation, D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10. CARE (
CONT
Avoid when choosing a detergent:
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: Chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc.,
are highly explosive and should never be used close to a range.
E
:
NAMEL FINISH
Clean with warm water and mild detergent only. If discoloration occurs, use a good enamel polish
such as automotive polish. (DO NOT use rough abrasive cleaner or porcelain cleaner.)

11. OPERATION

Always turn on the hood before begining cooking in order to establish an air flow in the kitchen. Let
the blower(s) run for a few minutes to clear the air after turning off the range.
Following are all the controls used by the hood models covered in this manual. Identify the one
installed on your hood and see how to operate it.
R
S
OCKER
WITCH
HC0020
A. ON/OFF B
LOWER AND
This 3-position rocker switch controls the blower speed. Pressing on left side (1) will result in
low speed operation, while pressing on right side (2) will turn on the blower to high speed. To
stop the blower operation, set the rocker switch to the central position (0).
B. ON/OFF L
IGHTING
This 3-position rocker switch controls the lighting level. According to your needs, press on left
side (1) to get nightlight intensity, or press on right side (2) to obtain full lighting. To shut off the
lights, set the rocker switch to the central position (0).
'
)
D
C
ONTROL
A
S
C
PEED
ONTROL
I
C
NTENSITY
ONTROL
B
S
:
WITCH
S
:
WITCH
- 11 -

Publicité

Table des Matières
loading

Table des Matières