Moving And Transportation; Transport - MCS XL 9ERM Manuel D'utilisation Et De Maintenance

www.MCS-Heater.com

MOVING AND TRANSPORTATION

NOTICE: Before raising or moving the machine
ensure that the fuel tank caps (F and H Fig. 3) are
firmly closed.

TRANSPORT

The generator is easy to move and it may be fixed in a
raised position thanks to its special eye-bolt mechanism
(B Fig. 3 or Fig. 7). This enables it to be set in the most
suitable position for heating, defrosting and drying.
Figur 7 - Hooks in order to raise
MOVEMENT
Before picking up or moving the machine you must check
to insure that the tank caps (G Fig. 3) are tightly shut. The
generator may be supplied with a rotating wheel. In this
case, if the flooring allows it you may push the generator
like a cart. In the case the machine does not have rotat-
ing wheels it is necessary to unblock the hinge (P Fig.
4) located on one of the lateral struts of the generator.
Lower the handle from its "resting position" (Fig. 8) Turn
the handle to the "transportation position" (Fig. 9). Lift the
generator and position it so that it is resting on the two
anterior wheels.
Figur 8 - Position close handles
800 292-3279
Figur 9 - Position open handles
WARNING: Before moving the machine you must:
turn the machine off by following the indications
provided in paragraph "TURNING OFF THE HEAT-
ER"; unplug the electrical source by pulling the
plug out of the wall and waiting for the generator to
cool down.
6
en