Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 4
Caution: It is wise to wear
leather gloves while attaching
the Springs. Be careful where you
place your hands as the Springs
and frame joints can pinch.
Attach the Springs (8) as follows:
Hook one end of a Spring (8) into a
V-ring sewn on the Jump mat. Hook
a Spring tool (10) shown as the inset
drawing in next to the free end of
the Spring(8 ). Pull it by the spring
tool(10) until it reaches the frame.
Push the end of the Spring into a hole
in the frame. Unhook the Spring tool.
the first spring will be attached.
Follow the diagram to install each
spring in the correct order. After the
first spring (#1) has been attached to
both mat and frame attach the sec-
ond spring (#2), the third (#3), etc..
Make sure to count the holes in the
frame and V-rings of the mat in the
apropriate position. Contine following
the order until the first 8 springs have
been attached. Be sure to match the
correct mat ring to the correct frame
hole. After the first 8 springs have
been attached continue to attach all
remaining springs to the mat and
frame in any order.
Note:The spring has a large hook
which attaches to the frame and a
small hook which attaches to the
mat ring.
Safety Notice:
as you attach Springs, carefully count
the V-rings and frame holes. If a V-
ring or a hole is skipped, reattach the
spring in the proper position.
WARNING!! : Please be careful where your hands and other parts of the
body are placed as the connector points and spring attachments can cre-
ate hand or body traps.
16
JumpArenA
4
V-ring
#8
#4
#7
#1
#2
#3
8ft
1
14
28
10ft
1
16
32
12ft
1
18
36
14ft
1
22
44
Trampolines
7
8
10
Frame
#1
#5
#6
#3
#4
#5
#6
#7
42
7
21
35
48
8
24
40
54
9
27
45
66
11
33
55
#2
#8
49
56
63
77
Publicité
Table des Matières
