EXIT Toys JumpArenA 244 Mode D'emploi page 15

STEP 1
Lay two Top Tubes (1) with Socket on
the ground in the positions as shown.
Make sure the Top Tubes are turned
so the small holes (spring holes) are
facing the ground.
Insert one end of the Top tube (1)
with socket into the other Top tube
with socket as shown.
STEP 2
The peak of the Leg Brace should
point toward the ground. Insert the
Leg Brace(2) into the Leg exten-
sion(3), secure with M6x45mm
Bolt(4) , M6 Nut(5) and M6 Wah-
ser(6).
firstly insert the leg halfway into the
socket, after that insert the other leg
halfway into the socket. Then press
down on both legs, so they are fully
inserted and secure them with
M6x45mm Bolt(4), M6 Nut(5) and M6
Washer(6)
Note: do not tighten the Nuts
Repeat steps1 and 2 additional three
times to assemble three rest leg sec-
tions.
STEP 3
Note: This step requires two per-
sons.
During this step, you will connect the
four assembled leg sections with the
remaining four leg top tubes. Stand
two leg sections and hold them in
the positions as shown. Slide the
large end of one of the remaining
Top Tubes onto the small end of the
indicated Top Tube on one of the leg
sections. Insert the small end of the
Top Tube into the indicated Top Tube
with socket on the other leg section.
Repeat this step until all four leg sec-
tions are connected. When this step
is completed, the frame will be fully
assembled and freestanding.
JumpArenA
1
1
2
leg extension (3)
Stütz-Verlängerungen (3)
pootverlengstuk (3)
Jambe d'extension (3)
make sure the two holes are aligned
sicherstellen, dass die beiden Löcher ausgerichtet sind
zorg ervoor dat de twee gaten zijn uitgelijnd
assurez-vous que les deux trous sont alignés
6
4
4
6
6
3
large end
small end
Trampolines
1
plastic sleeve
Kunststoffhülse
plastic koker
manchon en plastique
2
6
5
4
6
3
3
4
6
5
5
6
6
5
15