Water Tank; External Vacuuming - Bosch GDC 42 W Instructions D'emploi

EURO • Printed in Brazil • BA 1 609 929 B41 • GDC 42 W • GB • OSW 08/01
GDC 42 W - Buch Seite 3 Donnerstag, 26. Juli 2001 3:48 15
Wet-cutting
The machine may only be used for wet-cut-
ting when water-cooled.
Hose set 18
B B
If the water tank 1 is mounted, remove it by lifting
it off. Screw the adapter to the water tap and at-
tach the hose firmly onto the hose nipple 19.
The machine has a valve which regulates the wa-
ter-flow for cooling. The valve is activated as
soon as the machine is switched on.

Water tank 1

Place the water tank 1 onto the front part of the
handle 4 and press downwards. Make sure that
the hole with the rubber sleeve and the hose nip-
ple 19 are in alignment.
Do not fill below the minimum filling quan-
tity; observe the marking given on the wa-
ter tank 1.
Dry-cutting
For dry-cutting the machine may only be
operated if a dust extractor is connected.
The dust that is produced while
working can be detrimental to
health, inflammable or explo-
sive. Suitable safety measures
are required.
Examples: Some dusts are re-
garded as carcinogenic. Use
suitable dust/chip
and wear a dust mask.

External Vacuuming

The machine can be plugged directly into the re-
ceptacle of a Bosch general-purpose vac with re-
mote starting control. The vac starts automati-
cally when the machine is switched on.
The vacuum cleaner must be suitable for the ma-
terial to be worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special
vacuum cleaner.
Bosch offers suitable vacuum cleaners for all ma-
terials to be worked.
For dust extraction using an external vacuum
cleaner, a suction adapter must be used in this
case (see accessories). Insert the suction
adapter and suction hose fixture firmly.
13 • 1 609 929 B41 • TMS • 23.07.01
Adjusting the Cutting Angle
C
Loosen winged screw 21.
Pivot the machine sidewards until the desired
cutting angle is set to the scale 20.
Tighten winged screw 21 again.
Note: For mitre cutting, the cutting depth is
smaller than the value shown on the cutting depth
scale 8.
Adjusting the Cutting Depth
D
For changing the cutting depth, loosen the
winged screw 9 and raise the diamond cutter
from the base plate, or lower it to the base plate,
respectively:
Raise
Lower
Set the desired depth on the cutting depth
scale 8.
Retighten the winged screw 9.
extraction
For obtaining an optimum cut, the diamond cut-
ting disc must protrude 2 mm from the material.
Note: For mitre cutting, the cutting depth is
smaller than the value shown on the cutting depth
scale 8.
English - 3
for smaller cutting depths
for greater cutting depths