Preparing The Mower For Long-Term Storage; Preparing The Mower For Transport; Technical Data; Ordering Spare Parts - EINHELL BG-PM 46 S-SE Instructions De Montage Et Mode D'emploi

Anleitung BG-PM 46_S-SE_SPK1:_
GB
arising from improper repairs. Such work should be
performed by a customer services workshop or
authorized specialist. The same applies to accessory
parts.
12.10. Times of use
Lawn mowers are only permitted to be used on
workdays between the hours of 7.00 a.m. and 7.00
p.m. Please comply with statutory regulations, which
may vary from location to location.
13. Preparing the mower for long-term
storage
Caution: Do not empty the petrol tank in enclosed
areas, near fire or when smoking. Petrol fumes can
cause explosions and fire.
1. Empty the petrol tank with a petrol suction pump.
2. Start the engine and let it run until any remaining
petrol has been used up.
3. Change the oil at the end of every season. To do
so, remove the used engine oil from a warm
engine and refill with fresh oil (see Changing the
oil, item 12/4).
4. Remove the spark plug from the cylinder head.
Fill the cylinder with approx. 20 ml of oil from an
oil can. Slowly pull back the starter handle, which
will bathe the cylinder wall with oil. Screw the
spark plug back in.
5. Clean the cooling fins of the cylinder and the
housing.
6. Be sure to clean the entire machine to protect
the paint.
7. Store the machine in a well-ventilated place.
14. Preparing the mower for
transportation
1. Empty the petrol tank (see item 13/1).
2. Always let the engine run until it has used up the
remainder of petrol in the tank.
3. Empty the engine oil from the warm engine.
4. Remove the spark plug boot from the spark plug.
5. Clean the cooling fins of the cylinder and the
housing.
6. Unhook the starter cord from the hook (Fig. 7).
Release the quick-lock lever and swing the upper
push bar down (Fig. 4-5). Make sure that the
cords do not get kinked when the bar is pulled
up.
7. Wedge a few layers of corrugated cardboard
between the upper and lower push bars and the
engine in order to prevent any chafing.
26
24.09.2007 11:39 Uhr Seite 26

15. Technical data

Engine type:
Single cylinder four-stroke engine, 135 ccm
Engine power:
Working speed:
Fuel:
Tank capacity:
Petrol filling level:
Engine oil:
Spark plug:
Electrode spacing:
Cutting height adjustment:
Cutting width:
L sound pressure level:
pA
L sound power level:
WA
Vibration a
hw
Weight:

16. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
2.75 kW/3.75 HP
approx. 3100 min -1
Lead-free standard petrol
approx. 1.3 l
approx. 1.1 l
approx. 0.6 l / 15W40
F6 TC
0.5 – 0.6 mm
central, 5 levels (32-70 mm)
460 mm
76 dB(A)
96 dB(A)
2.56 m/s 2
34 kg