Assembling The Device - Bartscher 3702303 Mode D'emploi

•
The room in which the device is to be used must be well-ventilated. The ventilation
installation must be composed of non-flammable materials resistant to high
temperatures, with an open hood.
•
To move the device, remove its plug from the socket, close the gas valves and wait for
it to cool completely.
•
If the device is used without its motor, rotate the meat on the skewer using the
handle at the bottom.
•
If the odor of gas is detected, close all of the device's gas valves and external gas
installations, then thoroughly ventilate the room. Summon a competent maintenance
service immediately.
•
Never check if gas lines and valves are airtight using matches or a lighter. Use an
appropriate spray or foam for detecting leaks.
•
When finished using the device or when malfunctions occur, close all gas valves,
gas sources and disconnect the power source.
•
The device can only be used in accordance with its intended function.
•
When the device is in operation, protect it from impacts and do not move it.
•
When using the device, ensure that grease does not drip onto the floor. If grease
does drip on the floor, remove it immediately, otherwise accidents and injury may
result from slips and falls.
•
When moving the device, prevent it from being impacted or falling.
•
Do not leave any flammable materials near the device. Do not activate the device if it
is near flammable materials.
•
The gas pressure values appropriate for a given device are located on the rating
plate. The device may only be used with the gas pressure values given therein.
•
If the device is supplied by an LPG cylinder, the distance between the cylinder and
the device must be at least 50 cm.

5.2 Assembling the device

•
Assemble the motor in accordance with the provided instructions, mount the drip tray
and perforated plate cover onto the device.
•
To place meat in the device, loosen the lower arm and upper fastener. Use the
fasteners to regulate the distance between the skewer with meat and the burners.
•
Adjust the pressure values according to the information on the device's rating plate,
then insert the power cord into a socket. The device is ready for operation.
- 36 -