Cleaning And Care Of The Unit; Disposal - Beurer BF 700 Mode D'emploi

Unknown measurements
If measurements cannot be assigned to any user, the scale stores them as unknown measurements. Up to
20 unknown measurements are saved on the scale.
You can use the app to directly assign unknown measurements to your user.
Saving the assigned measurements on the scale
If the app is open and there is an active Bluetooth
are sent immediately to the app. In this case, the values are not saved on the scale.
If the app is not open, the newly assigned measurements are saved on the scale. A total of 30 measure-
ments per user can be saved on the scale. The saved measurements are transferred automatically to the
app if you open the app within the Bluetooth
Data synchronisation takes place within 10 seconds. It is possible to automatically transfer data when the
scale is switched off.
Deleting scale data
If you would like to completely delete all measurements and old user data on the scale, switch on the
scale and press the reset button for approx. 3 seconds.
" " will appear in the display for several seconds.
This is necessary if you would like to delete scale users who have been set up incorrectly or are no longer
required, for example.
You must then carry out the actions in chapter 7 again (user assignment).
Replacing batteries
Your scale is equipped with a "low battery indicator". If you operate the scale with flat batteries, "Lo"
will appear on the display and the scale will automatically switch off. In this case, the batteries must be
replaced (3 x 1.5 V AAA).
NOTE:
• When changing batteries, always use batteries of the same type, brand and capacity.
• Do not use rechargeable batteries.
• Use batteries that are free of heavy metals.

11. Cleaning and care of the unit

The unit should be cleaned occasionally.
Clean using a damp cloth, to which you can apply a little detergent if necessary.
IMPORTANT
• Do not use aggressive solvents or cleaning agents!
• Never immerse the unit in water!
• Do not wash the unit in a dishwasher!

12. Disposal

The empty, completely flat batteries must be disposed of through specially designated collection boxes,
recycling points or electronics retailers. You are legally required to dispose of the batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
For environmental reasons, do not dispose of the device in the household waste at the end of its useful
life. Dispose of the unit at a suitable local collection or recycling point.
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for waste
disposal.
connection to the scale, newly assigned measurements
®
range.
®
19