GE Monogram ZEK938 Manuel Du Propriétaire page 40

Trouble-
shooting
tips
40
PROBLEM
OVEN DOOR WILL
NOT OPEN AFTER
A CLEAN CYCLE
OVEN NOT CLEAN
AFTER A CLEAN
CYCLE
"LOCK"
FLASHES IN
THE DISPLAY
LOCKED LIGHT
IS ON WHEN YOU
WANT TO COOK
CONTROL SIGNALS
AFTER ENTERING
COOKING TIME OR
DELAY START
OR LETTER" FLASH
IN THE DISPLAY
DISPLAY GOES
BLANK
DISPLAY FLASHES
UNABLE TO GET
THE DISPLAY TO
SHOW "SF"
"PROBE" APPEARS
IN THE DISPLAY
POWER OUTAGE,
CLOCK FLASHES
STEAM FROM
THE VENT
"BURNING" OR
"OILY" ODOR
EMITTING FROM
THE VENT
STRONG ODOR
FAN NOISE
POSSIBLE CAUSE
• The oven is too hot. Allow the oven to cool below locking temperature.
• Oven controls improperly set. See the Using the Self-Cleaning Oven section.
• Oven was heavily soiled. Clean up heavy spillovers before starting the
clean cycle. Heavily soiled ovens may need to self-clean again or for a
longer period of time.
• The self-clean cycle has been selected but the door is not closed.
Close the oven door.
• The oven door is locked because the temperature inside the oven has
not dropped below the locking temperature. Press the CLEAR/OFF
pad. Allow the oven to cool.
• You forgot to enter a bake temperature or cleaning time. Press the
BAKE pad and desired temperature or the SELF CLEAN STD/LOW
pad and desired clean time.
• You have a function error code. Press the CLEAR/OFF pad. Allow the
oven to cool for one hour. Put the oven back into operation.
• Disconnect all power to the oven for 30 seconds and then reconnect
power. If the function error code repeats, call for service.
• A fuse in your home may be blown or the circuit breaker tripped.
Replace the fuse or reset the circuit breaker.
• The clock is in the black-out mode. See the Oven Control, Clock and
Timer section.
• Power failure. Reset the clock.
• Oven control pads were not pressed properly. The BAKE and the
BROIL HIGH/LOW pads must be pressed at the same time and held
for 3 seconds.
• This is reminding you to enter a probe temperature after plugging in
the probe. Enter a probe temperature.
• Power outage or surge. Reset the clock. If the oven was in use, you
must reset it by pressing the CLEAR/OFF pad, setting the clock and
resetting any cooking function.
• When using the convection feature, it is normal to see steam coming out
of the oven vent. As the number of racks or amount of food being cooked
increases, the amount of visible steam will increase.
• This is normal in a new oven and will disappear in time. To speed the
process, set a self-clean cycle for a minimum of 3 hours. See the Using the
Self-Cleaning Oven section.
• This is temporary. An odor from the insulation around the inside of the
oven is normal for the first few times the oven is used.
• A cooling fan or a convection fan (depending on the function you are using)
may automatically turn on. This is normal. The cooling fan will turn on to cool
internal parts. It may run for up to 1-1/2 hours in 30 models and up to 2
hours in 27 models after the oven is turned off.
The convection fan will cycle on and off until the function is over or
the door is opened.
Before You Call For Service...
Wall Oven