Functions Of Deluxe System; Control Panel; Remote Control; Dry-Run Protection - HOESCH Deluxe Instructions De Montage Et D'utilisation

09

Functions of Deluxe system

09.01 Control panel

The bathtub with whirlpool system is ready to use when
minimum water level is achived. Readyness / stand by
of whirlpool bathtub is indicated by green diode; you can
fi nd the diode on the disinfection tank. (In case of additional
accesories - the control panel: it is indicated by LED diode
at the bottom of the panel)
1
Press key = massage ON/OFF (highest power)
Permanent pressure = increase massage power
2
Permanent pressure = reduce massage power
3
Press key = interval ON/OFF
4
Press key = air-admix ON/OFF
5
Press key = air-bubbling ON/OFF
Permanent pressure = increase bubbling
6
Permanent pressure = reduce bubbling
Press key = interim fl ushing ON/OFF
Interim fl ushing is possible when the tub is em-
pty and automatic fl ushing is off (no red lamp
illuminated).
7
Switching off the interim fl ushing is not necessary,
because it is part of a preset program and swit-
ches off automatically.
8
Press key = light ON/OFF
Green LED diode
Whirltub ready to work/standby, i.e. the minimum
9
water level has been reached
Red LED diode
10
The light is on during the rinsing process

09.02 Remote control

⚠
Please read the separate REMOTE CONTROL
WITH TOUCH SCREEN instruction manual
before commissioning.
10

Dry-run protection

Hoesch Deluxe bathtub with whirlpool system is equipped
with "dry run" protection. The whirlpool pump and the light-
ing can be started only when the green LED diode is on.
The "dry run" protection protects the system against start
up when the bathtub is empty or the water level is too low.
Minimum height of water level
Minimum height
of water level
11 Automatic preliminary and fi nal
fl ushing
Preprogrammed rinsing programmes guarantee that all
whirlpool bathtub components are rinsed both before and
after the bathing. Pre-rinsing (Airsystem, Whirlsystem i
Whirl- +Airsystem) stars automatically when the bathtub is
fi lling. It takes about 5 minutes and uses from 10 to 13 litres
of water depends on the bathtub model. Finishing rinsing
(Airsystem, Whirlsystem i Whirl- +Airsystem) starts auto-
matically when the bathtub is empting. It takes about 10
GB
25