Overfl Ow Adjusting Knob; Cleaning / Maintenance; Cleaning & Maintenance; Drainage Valve - HOESCH Deluxe Instructions De Montage Et D'utilisation

After a bath rinse the bathtub surface with water and wipe it
with a wet cloth. Do not use scrubbing agents! When oc-
casionally cleaning the bathtub thoroughly, spread a couple
drops of the cleaning agent on the surface and wipe it with
a soft cloth. Remove heavier dirt using warm water and a
mild liquid cleaning agent, or soap water.
Calcifi cations should be removed with the use of lime re-
moving vinegar and water (do not use these for fittings!).
In case of using the agents for cleaning drains please ob-
serve the usage instructions!
Small scratchings or fragments of the shiny surface that
have lost their smoothness should be removed with the use
of e.g. the HOESCH maintenance set, article No.: 699100.
Tip:
Fittings and built-in elements should be cleaned with a
soft cloth. Damages caused as a result of improper usage
of chemicals, acids and scrubbing agents will not be taken
into consideration by us as the reason of a complaint.
15.01 Overfl ow adjusting knob
Close the drain
16

16.01 Drainage valve

Open the drain

Cleaning / maintenance

To protect the whirlpump from impurities, a fi lter is integra-
ted in the drain. When inserting the drainage valve, ensure
that the lower pin is exactly centred in the hole foreseen.
The position of the overfl ow regulator indicates whether the
drain is open or closed.
⚠

16.02 Venturi nozzle units Deluxe

The nozzles must be dismantled and cleaned when water
starts to spray from the nozzle while the cleaning program
is running. It is normal for water drops to exit during the
cleaning program. This is unavoidable due to the smooth
running design of the interior components.
To remove the nozzle unit
surface of the nozzle key
nozzle unit
turning the key anti-clockwise (to the left).
The Venturi unit/injector
housing using the narrow side of the nozzle key
removing the nozzle unit, check whether foreign bodies or
lime deposits are the cause of the leak. Parts with lime de-
posits can be cleaned with an acid, lime-dissolving subs-
tance (e.g. diluted vinegar).
Cleaning / maintenance
3mm
3mm
The integrated sieve in the drainage valve
must be cleaned regularly.
A blocked fi lter impairs the suction power of
the whirl pump and consequently the perfor-
mance.
Faulty functioning results!
completely, place the friction
2
on the cover ring. The entire
1
can be removed by applying pressure and
2
can be removed from the nozzle
3
GB
. After
1
27