Operating Manual; Introduction; How Does The Whirl System Function; How Does The Air System Function - HOESCH Reviva II EF02 Instructions De Montage Et D'utilisation

07

Operating manual

Finally: you are about to bath for the first time in your HOESCH whirltub! We wish you a lot of pleasure in your
new bathtub! The fact that you have a highest quality product is the effect of constant monitoring of the product,
research and development works in connection with the innovative design of our luxurious bathtubs made of
sanitary acrylic. However, in order for your bathing not to be disturbed, we suggest reading this manual first.
08

Introduction

08.01 How does the whirl system function?

Whirl system installation has closed circulation. Drain valve is, at the same time, a suction bracket. Water is sucked,
fl owed by water pump and directed with 1 bar pressure through jets inside the bathtub. Thanks to sub-pressure the self-
aeration of water stream takes place (possibility to turn on/turn off with remote control). Pipes between jets and water
pump are installed in the way that they are made empty at the releasing water from the bath. In Whirlpower-System
additional air is added from the blower, what causes even more powerful massage. Thanks to rotating jets, this massage
stream is evenly distributed throughout the entire body.

08.02 How does the Air system function?

The air sucked by the blower is carried by air pipes located under the bottom of the bathtub and via bottom nozzles to the
inside of the bathtub full of water.
09

Functions of Reviva system

09.01 Control panel

After reaching the minimum water level, the whirltub is ready to work. The ready to work/standby status is indicated by
the green LED diode.
1 Whirl system ON/OFF Press the button shortly. After
switching the whirl system on the pump starts working
with full power.
2 By permanently pressing the +/- buttons you
can individually adjust the power. By pressing/holding
those buttons the pump power is decreased or
increased.
4 Air system ON/OFF Press the button shortly. After
switching the Air system on the blower switches
on slowly to the medium power level.
5 By permanently pressing the +/- buttons you
can individually adjust the power. By pressing/holding
those buttons the blower power is decreased or
increased.
3/6 Interval mode ON/OFF
With the active interval mode the massage power
changes periodically from the lowest to the highest.
In order to stop the interval mode press the buttons again.
2 1 5
3 8 6
4 10 12
7 9 11
7 Plus Airsystem ON/OFF
Can be additionally switched on and off with
Whirlpower + Air.
8 Whirlpower ON/OFF
Can be additionally switched on and off in the Whirl
mode.
9 Underwater LED spotlights ON/OFF
During LED chrome therapy, white colour is activated
at pushing the button. Pressing the button again turns
on red, orange, yellow, green, indygo, violet colours,
colours sequence I, colours sequence II. To turn off, the
button should be pressed continuously for 4 seconds.
10 Starts semi-automatic disinfection, hold the button
for min. 3 seconds.
11 Switch off everything
switching all functions off
12 LED display green, yellow, red instead of display
module
GB
21