Automatic Switching-Off Of The System; Ozonation (Only With Airsystem, Whirlpower And Whirlpower + Air); System Drying (Only With Airsystem, Whirlpower And Whirlpower + Air); Disinfection - HOESCH Reviva II EF02 Instructions De Montage Et D'utilisation

12

Automatic switching-off of the system

The operational time of the system is limited to 25 minutes. After 25 minutes, regardless of the buttons switched on,
the system switches-off automatically. By pressing button 1 and/or 4 you can switch the system on again.
13

Ozonation (only with Airsystem, Whirlpower and Whirlpower + Air)

Ozonization is automatically activated when the blower is turned on.
14

System drying (only with Airsystem, Whirlpower and Whirlpower + Air)

The system drying function is switched on automatically approx. 10 minutes after emptying the bathtub. After switching
on it works in total for about 2 minutes, during which the blower works for the fi rst 30 seconds with medium power,
and for the next 90 seconds with full power. While emptying the bathtub you can manually switch on the system drying
of air and whirl jets by pressing button 4 (duration approx. 2 minutes). The system drying can be switched-off at any
moment.
15

Disinfection

Regular disinfection of your whirltub guarantees optimal hygiene. When the tub is not used for longer period
of time, it is necessary to make disinfection before running the tub! If disinfection is necessary, you will be
informed about that with yellow LED diode lighting up when you finish the bath. In order to run disinfection,
there must be certain level of water- alternatively, the water level must be raised to the required level at which it
is also possible to activate underwater spotlight.
⚠
We do not hold the responsibility for damages and threats occurred because of usage of other agents
not intended for this purpose.
■ After leaving the bathtub pour the disinfecting agent into it (follow
the producer's instructions!). In automatic disinfection system (No. 69712)
the disinfecting agent (follow the producer's instructions!) has to be
placed in the disinfectant container. See drawing. We recommend using
the disinfecting agent with the article No. 6923 or 133607.
Dosing for Art.-Nr. 133607 can differ!
Suggested amounts: 100 ml of the disinfecting agent for 100 L of the bathtub
capacity.
Producers tips should be observed
■ Start the disinfection by pressing „Des" button 10 (hold the button pressed
for min. 3 seconds). During the disinfection (duration time approx. 30
minutes) the red LED diode is on.
The process of the disinfection
■ First the system works for 1 minute in order to distribute the disinfecting agent.
■ After the time of the agent's interaction, which lasts 27 minutes, the system is switched on again for 2 minutes.
■ After fi nishing the programme, the red LED diode starts pulsating, which means that the bathtub should be
emptied.
■ After emptying the bathtub and rinsing its surface, pipes of air and water jets are automatically dried up
(only with Airsystem, Whirlpower and Whirlpower + Air)
■ If the disinfection process is interrupted, the yellow LED diode will be still on!
GB
MAX 500ml
23