Start-Up Instructions; Illustrated Description; Operating Instructions; Start-Up - stayer LS1200 Instructions D'emploi

Avoid your body from entering the area in which the
electronic equipment eventually moves during
backlashes. A backlash pushes the electrical tool in the
opposite direction to the movement of the grinding disc at
the point where it becomes blocked.
TWork taking particular care near corners, sharp
tubes, etc. Avoid the tool bouncing off the piece being
processed and becoming jammed. The rotating
application tool tends to get jammed on corners, sharp
edges or when bouncing off the piece being processed.
This leads to a loss of control or a backlash.
Special safety indications for roughing
Exclusively use approved roughing elements for this
electrical tool with its corresponding protection cover.
Roughing elements not approved for this electrical tool
cannot be covered adequately therefore not being safe.
The protection cover will be firmly assembled on the
electrical tool and adjusted in such a way maximum
safety is achieved.That is to say, the smallest portion of
the uncovered grinding agent will be facing the operator.
The protection cover has the task of protecting the
operator from bit becoming detached and from any
eventual contact with the grinding element.
The grinding elements will be used exclusively for
their designated uses.
Part-off or roughing discs will not be used in this
electrical tool.
Other safety indications
Always hold the electrical tool with both hands on the
corresponding surfaces (motor casing and handle).
Hold smaller pieces to be processed in order to avoid
their involuntary displacement.
The power supply network voltage and the voltage
indications on the characteristics plate must coincide.
SYMBOLS USED
DANGER: This indicates an imminent danger. In the
case of non-compliance you will be at risk of death
or very serious injuries.
CAUTION: This indicates a situation that is possibly
dangerous. Non-compliance implies the risk of
injuries or material damages.
WARNING: This indicates advice regarding use
and important information.
SYMBOLS ON THE APPARATUS
Read the instructions before starting up the
equipment!
Use adequate protection!
ENGLISH
14
Elimination of unused machines.

3. Start-up Instructions

3.1. Illustrated Description

1 ON/OFF switch
2 Interlocking button
3 Protective Housing adjustment screw
4 Protective Housing
5 Grip
6 Adjustment wheel to select the rotation speed
7 Earth connection cable
8 Gear head
9 Drum shaft
10 Satin drum
11 Washer
12 Drum retention screw
13 Distancing ring*
14 Drive roller*
15 Rubber roller *
16 Ventilation grilles
17 Spindle blocking button
18 Brush cover
* The accessories described and illustrated do not correspond to the
serial material included. The complete range of optional accessories
is detailed in our accessory programme.

4.Operating Instructions

IF YOU FIND THE MACHINE IN POOR CONDI-
TION, OR WITH PROTECTIONS OR MISSING
PARTS, DO NOT CONNECT IT AND CONTACT
THE TECHNICAL SERVICE.

4.1. Start-up

Disconnect the power supply plug before
performing any work in the electrical equipment.
Prior to start-up.
Unpack the electrical tool and check the volume handed
over is complete and determine if any damage occurred
during its transport.
On/Off (Fig. 2)
- Press switch 1, keeping it pressed down.
- To stop the tool release switch 1.
Continued operation/interlocking (Fig. 2)
- Press interlocking switch 2 on the machine.
- To turn it off, press interlocking switch 2 for its deactivation.
Rotation speed pre-selection (Fig. 3)
- To adjust the working speed, turn speed selection wheel
6 to the required value.
Hold the tool or the tool support (Fig. 4)
- Disconnect the plug from the power supply.
- Press the spindle blocking button 17 and keep it pressed
down.
14