Minimum Flow Adjustment (5-Burner Version) - BORETTI BTG-80 Notice D'emploi

Minimum fl ow adjustment (5-burner version)
The minimum fl ow is correctly adjusted when the fl ame remains lit without a pot on the pan sup-
port in position 1 of the burner control.
To adjust the minimum fl ow of each burner, proceed as follows:
Press the "+" and "-" buttons simultaneously for approx. 3 seconds as shown in the fi gure above.
"MIN" will appear on the display indicating the activation of the adjustment procedure.
At this stage, select the burner to be adjusted using the "+" and "-" buttons. By pressing these
buttons repeatedly, a LED will light up showing the selected burner.
To confi rm the selected burner, press the timer button.
The selected burner will light on the minimum setting. To increase or decrease the minimum fl ow,
use the "+" and "-" buttons of the specifi c burner.
During the adjustment procedure, the selected burner display will show "-" if the set minimum level
corresponds to the factory setting.
^ or v will fl ash on the display if the fl ow rate is respectively higher or lower than the preset fl ow
rate.
To go to the next burner, repeat the procedure from the second fi gure.
After adjusting all the burners, press the timer button again to exit the procedure. The minimum
fl ow settings are saved and will be used each time you use the appliance.
76