Auxiliary Input Socket - Makita DMR300 Manuel D'instruction

Open the cover and insert the adaptor plug into the DC IN socket
on the side of the radio. Plug the adaptor into a standard mains
socket outlet. While the radio is powered from AC power adaptor,
the indicator for AC power supply (
► 1. Cover 2. DC IN socket 3. Adaptor plug
NOTE: When the adaptor is used, the radio is powered
from the mains and the battery cartridge is charged.
NOTE: When the radio has any interference in AM
band by its AC adaptor, move the radio away from the
AC adaptor further than 30 cm (1 feet).

Auxiliary input socket

1
► 1. AUX IN 1 2. AUX IN 2
Two 3.5 mm stereo auxiliary input sockets are provided.
One is at the front of the radio (AUX IN 1); the other is
located in the battery compartment (AUX IN 2).
1. Connect an external audio source, such as a MP3
or CD player, to the auxiliary input socket.
2.
Repeatedly press and release the Source but-
ton until AUX IN 1 or 2 is displayed.
) will appear on the display.
1
2 3
2
11 ENGLISH
3. Adjust the volume setting on your external audio source to
ensure an adequate signal level. After that, use the Tuning con-
trol knob on the radio as needed for comfortable listening.
Charging with USB power supply port
CAUTION:
Do not connect power source to
USB port. Otherwise there is risk of fire. The USB
port is only intended for charging lower voltage
device. Always place the cover onto the USB port
when not charging the lower voltage device.
CAUTION:
Do not insert a nail, wire, etc. into
USB power supply port. Otherwise a circuit short
may cause smoke and fire.
NOTICE:
Before connecting USB device to the
charger, always backup your data of USB device.
Otherwise your data may lose by any possibility.
NOTICE:
When not using or after charging, remove
the USB cable and close the cover.
NOTICE:
Do not connect this USB socket with your
PC USB port, as it is highly possible that it may cause
breakdown of the units.
NOTE: The charger may not supply power to some
USB devices.
There are USB power supply ports at the front and back
side of the radio. You can charge USB device through
the USB power supply port.
► 1. USB power supply port
1. Connect the USB device, such as a MP3 or CD
player, to the USB power supply port using a USB cable
available in the market.
2. Press the Power button
radio.
1
to switch on the