Using Your Refrigerator; Ensuring Proper Air Circulation; Prior To Use; Control Panel Features - LG LSXS22423 Série Manuel D'utilisateur

ENSURING PROPER AIR CIRCULATION

between the refrigerator and freezer sections.
• Cool air enters the freezer through the vents located
at the top of the compartment and exits through the
vents located behind the freezer drawers.
• Cool air from the freezer section enters the fresh food
section through vents located at the top of the
compartment. The air moves down throughout the
compartment and exits through the vents located
behind the crisper drawers.
• Do not block any of these vents with food packages.
temperature and moisture problems may occur.
IMPORTANT:
Because air circulates between both sections, any odors
formed in one section will transfer to the other. You
MUST thoroughly clean both sections to eliminate odors.
To prevent odor transfer and dried out food, wrap or
cover foods tightly. (See the Food Storage Guide
section for details.)
NOTE: If you close the
refrigerator door, you may see
the freezer door open and
close again due to pressure

PRIOR TO USE

1. Clean your refrigerator thoroughly and wipe off dust
accumulated during shipping.
2.Install accessories such as ice cube bin, drawers,
shelves, etc., in their proper places. They are packed
together to prevent possible damage during shipment.
3.Let your refrigerator run for at least 2 or 3 hours
the freezer compartment to ensure proper cooling.
Your refrigerator is now ready for use.

USING YOUR REFRIGERATOR

CONTROL PANEL FEATURES

REFRIGERATOR AND FREEZER CONTROLS

It's recommended to maintain the initial (middle)
temperature settings by pressing the Refrigerator Temp
button and Freezer Temp button.
NOTE: When changing control settings, wait 24
The controls are set correctly when milk or juice is as
cold as you would like and when ice cream is tempera-
ture in either compartment is too cold or too warm,
change the setting one increment at a time. Wait 24
hours for the change to stabilize before adjusting again.
Ice & Water Dispenser
Select Water, Crushed or Cubed Ice by pressing the
ICE & WATER button to the selection desired. The
Water, Crushed Ice or Cubed Ice icon will light up to
indicate the selection.
To dispense water or ice, gently push your cup against
the dispenser pad.
NOTE: Hold your cup in place for a couple of seconds
after dispensing ice or water so the last few drops go in
your cup instead of on the floor.
15
Max
Min
Off
hours before making additional adjustments.
The more lit bars, the colder the refrigerator
and freezer will be. See Figure 1.
Selecting this icon indicates that cubed ice
will be dispensed when the dispenser pad is
activated.
Selecting this icon indicates that water will be
dispensed when the dispenser pad is activated.
Selecting this icon indicates that crushed ice
will be dispensed when the dispenser pad is
activated.
Max
Min
Off