Installation Instructions - AVG TBWC-110S4 Manuel D'utilisation

3.

INSTALLATION INSTRUCTIONS

BEFORE USING YOUR WINE COOLER
a. Remove the exterior and interior packaging.
b. Before connecting the Wine Cooler to the power source, let it stand upright for
approximately two (2) hours. This will reduce the possibility of a malfunction in the cooling
system that may be caused from handling during transportation.
c. Clean the interior surface with lukewarm water using a soft cloth.
d. Install the handle on the left side of the door.
INSTALLATION OF THE BUILT-IN MODELS
a. Level the unit starting from the inside of the cabinet.
b. Open the door of the unit at a 90° angle.
INSTALLATION OF YOUR WINE COOLER
a. This appliance is designed for free standing installation or built-in (fully recessed).
b. Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded.
To level your Wine Cooler, adjust the front leveling leg at the bottom of the unit.
c. Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the unit to not
perform properly.
d. Avoid locating the unit in humid areas.
e. Plug the Wine Cooler into an exclusive, properly installed, grounded wall outlet. Do not,
under any circumstances, cut or remove the third (ground) prong from the power cord. Any
questions concerning about power and/or grounding should be directed to a certified
electrician or an authorized product Service Center.
21