Cleaning And Maintenance; Storage; Disposal; What If There Are Problems - Beurer FW 20 Cosy Mode D'emploi

Chauffe-pieds
Masquer les pouces Voir aussi pour FW 20 Cosy:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13

5. Cleaning and maintenance

WARNING
Before cleaning, always remove the mains plug from the socket first.
Otherwise there is a risk of electric shock.
CAUTION
• The controller must never come into contact with water or other liquids, as this may cause
damage.
To clean the controller, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
Small marks on the foot warmer can be removed with a damp cloth and, if necessary, with a little
liquid detergent for delicate laundry.
CAUTION
• Please note that the foot warmer may not be washed, chemically cleaned, wrung out, tumble dried,
put through a mangle or ironed. Failure to do so may damage the foot warmer.
The removable fleece lining can be washed by hand.
Use a delicate laundry detergent and measure it out according to the manufacturer's instructions.
WARNING
• Only use the foot warmer again once the foot warmer and fleece insert have fully dried. Otherwise
there is a risk of electric shock.

6. Storage

If you do not plan to use the foot warmer for a long period of time, we recommend that you store it in the
original packaging.
CAUTION
Please allow the foot warmer to cool down before storing. Failure to do so may damage the foot warmer.
To avoid breaking the foot warmer, do not place any objects on top of it whilst storing.

7. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its
useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the device
in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have
any questions, please contact the local authorities responsible for waste disposal.

8. What if there are problems?

Problem
The temperature settings are not illuminated while
- the mains plug is connected to a working socket
- the sliding switch is set to 1, 2 or 3

9. Technical data

See the rating label on the foot warmer.
Cause
The safety system
has switched the foot
warmer off permanently.
12
Solution
Send the foot warmer for
servicing.

Publicité

Table des Matières
loading

Table des Matières