Operation; Safety; Initial Use; Switching On - Beurer FW 20 Cosy Mode D'emploi

4. Operation

4.1 Safety

CAUTION
the foot warmer is fitted with a SAFETY SYSTEM. This sensor technology provides protection against
overheating across the entire surface of the foot warmer with an automatic switch-off in the event
of a fault. If the SAFETY SYSTEM has switched off the foot warmer, the temperature settings (4) are
no longer illuminated when switched on. Please note that, for safety reasons, the foot warmer can
no longer be operated after a fault has occurred and must be sent to the specified service address.

4.2 Initial use

Insert the mains plug into the socket.

4.3 Switching on

To switch the foot warmer on, set the sliding switch for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings (4) are illuminated when switched on.

4.4 Setting the temperature

Level 0: OFF
Level 1: minimum heat
Level 2: medium heat
Level 3: maximum heat
NOTE:
The fastest way to warm up the foot warmer is to initially set the highest temperature setting.
NOTE:
This foot warmer has a fast heating function, which allows the foot warmer to warm up
faster in the first 10 minutes.
WARNING
If the foot warmer is being used over several hours, we recommend that
you set the lowest temperature setting on the controller to avoid over-
heating the feet, which may lead to burns to the skin.

4.5 Automatic switch-off

This foot warmer is equipped with an automatic switch-off function. This turns off the heat sup-
ply approx. 90 minutes after the initial use of the foot warmer. The temperature setting display
then starts to flash. So that the foot warmer can be switched back on, the sliding switch for ON/
OFF and temperature settings (5) must first be set to setting "0" (OFF). After about 5 seconds
it is possible to switch it on again.

4.6 Switching off

To switch the foot warmer off, set the sliding switch for ON/OFF and temperature settings to setting "0" (OFF).
The temperature settings are then no longer illuminated.
NOTE:
If the foot warmer is not in use, switch the sliding switch for ON/OFF and temperature settings to
setting "0" (OFF) and unplug the mains plug from the socket.
11
90
min
STOP