Electrolux SG231N Notice D'utilisation page 49

Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMAT‐
IC or after changing the
temperature.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the
display.
The temperature in the
appliance is too low/too
high.
Door does not open easi‐
ly.
Possible cause
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FROSTMATIC func‐
tion is switched on.
This is normal, no error
has occurred.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FROSTMATIC or
COOLMATIC function is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The food products tem‐
perature is too high.
The FROSTMATIC func‐
tion is switched on.
You attempted to re-open
the door immediately after
closing.
ENGLISH
Solution
Refer to "Operation"/"Control
panel" chapter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FROSTMATIC
function".
The compressor starts after
some time.
Attach the melting water out‐
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "FROST‐
MATIC or COOLMATIC
function".
Keep the OK pressed for ap‐
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Refer to "FROSTMATIC
function".
Wait a few seconds between
closing and re-opening of the
door.
49