WIKA SL-1 Mode D'emploi page 9

7. Starting, operation
Assembly of L-connector DIN EN 175301-803
(D) Mounting hole
1. Loosen the screw (1).
2. Loosen the cable gland (2).
3. Pull the angle housing (5), with the
terminal block (6) inside, away from the
instrument.
4. Using the head of a small screwdriver in
the mounting hole (D), lever the terminal
block (6) out of the angle housing (5).
In order not to damage the sealing of the angle housing, do not try to push the terminal block
(6) out using the screw hole (1) or the cable gland (2).
5. Ensure that the conductor outer diameter you select is matched to the angle housing's cable
gland. Slide the cable through the cable gland nut (2), washer (3), gland seal (4) and angle
housing (5).
6. Connect the flying leads to the screw terminals on the terminal block (6) in accordance with
the pin-assignment drawing.
7. Press the terminal block (6) back into the angle housing (5).
8. Tighten the cable gland (2) around the cable. Make sure that the sealing isn't damaged and
that the cable gland and seals are assembled correctly in order to ensure ingress protection.
9. Place the flat, square gasket over the connection pins on the top of the instrument housing.
10. Slide the terminal block (6) onto the connection pins.
11. Secure the angle housing (5) and terminal block (6) to the instrument with the screw (1).
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi SL-1
(1)
(2)
(3)
(5)
(4)
(6)
EN
Female
connector
Sealing
Clamping nut,
Male connector,
Case with
pressure connection
9