Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CT 17 E
GB
6
Operation
WARNING
Unauthorised voltage or frequency!
Risk of accidents
Observe the specifications on the machine's
name plate.
Observe country-specific regulations.
6.1
Initial operation
Open the locking clips and remove the top sec-
tion of the machine [2].
Remove accessory parts and accompanying
documents [3].
Insert a filter bag [4].
6.2
Connecting the suction hose
For extracting material at the intake opening [1-1]
For blowing out material from the exhaust opening
[1-9]
6.3
Connecting the mobile dust extractor
WARNING
Risk of injury from tools starting up unexpectedly
Before setting the switch to the "AUTO" or
"MAN" position, make sure that the connected
tool is switched off.
The switch [1-2] serves as an on/off switch.
Switch position "0"
Appliance socket [1-4] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-4] is connected to the power,
the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-4] is connected to the power,
the mobile dust extractor starts when the connect-
ed tool is switched on.
Insert the plug into an earthed socket.
Pull the plug from the socket when the ma-
chine is not in use and prior to maintenance
and cleaning work.
12
6.4
Connecting electric power tools
WARNING
Risk of injury
Observe the maximum appliance socket con-
nected load (see chapter "Technical data")
Switch off the electric power tool.
Connect the electric power tool to the appliance
socket [1-4].
6.5
Adjusting the suction power
Use the rotary knob [1-3].
7
Working
7.1
Dust extraction
Extracting dry materials
Always use a filter bag.
Extracting wet materials/liquids
Remove the filter bag!
Insert a special wet filter.
The dust extractor stops automatically when the
maximum level is reached.
After wet extraction, allow the main filter to dry!
CAUTION
Escaping foam and fluids
Switch off and empty the machine immediately.
7.2
After finishing work
Switch off the mobile dust extractor and pull out
the mains plug.
Wind up the mains power cable.
Empty the dirt trap.
Place the mobile dust extractor in a dry room in-
accessible to unauthorised users.
8
Service and maintenance
WARNING
Risk of injury, electric shock
Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!
All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Publicité
Table des Matières
