Original Operating Manual - Festool CLEANTEX CT 17 E Notice D'utilisation D'origine

CT 17 E
GB

Original operating manual

1 Safety instructions
Warning! Read and observe all information and safety instructions.Ignoring
warning notes and instructions may lead to electric shocks, fires and/or cause seri-
ous injury.
Keep all safety information and other instructions in a safe place for future refer-
ence.
– This machine can be operated by children over 8 years of age and persons with re-
duced physical, sensory or mental capabilities or a lack of practical experience and
knowledge, provided they are supervised or have been instructed to use the ma-
chine safely and understand the dangers of machine operation. Children must not
play with the machine. Cleaning and user maintenance may not be performed by
children without supervision.
– Risk of explosion and fire hazard: do not extract sparks or hot dust, flammable or
explosive dust (e.g. magnesium, aluminium, petrol, thinner, with the exception of
wood), aggressive fluids/solids (e.g. acid, leach, solvent).
– Observe all national safety regulations as well as the material manufacturer's spec-
ifications!
– Not suitable for extracting hazardous dust.
– Always use suitable protective equipment!
– If intact following a visual inspection, work in a dry environment according to in-
structions!
– WARNING! Operating personnel must receive instructions on how to use the device.
Prior to use, operating personnel must receive information and instructions on how to
use the device and handle any materials involved as well as relevant training, including
safe procedures for disposing of the extracted materials.
– If foam or fluid starts to escape, switch off the machine immediately.
– Clean the fill level sensors [7] and inspect for damage at regular intervals.
– Not suitable for extracting fluids that foam excessively.
– Always operate with the filter system installed.
– Always use the socket on the machine for the purpose specified!
– Check the plug and the cable regularly and should either become damaged, in order
to avoid a hazard, have them replaced by an authorised after-sales service workshop.
– Do not lift or transport using a crane hook or lifting gear!
– If a fault occurs immediately turn off the device, disconnect from the mains, and get
checked and repaired by an authorised after-sales service workshop.
10