Velleman HAM200 Mode D'emploi page 7

Type 111 to deactivate the vibration alarm. The LED flashes
3.
3 times to confirm and the alarm returns to the disarmed mode.
Press 4 to arm the alarm.
4.
To reactivate the vibration alarm, proceed as follows:
Make sure that the alarm is disarmed.
1.
Type the security code to enter the setting mode.
2.
Type 222 to activate the vibration alarm. The LED flashes
3.
3 times to confirm and the alarm goes into disarmed mode.
Press 4 to arm the alarm.
4.
8. Troubleshooting
Problem: I installed the batteries, but the alarm did not beep.
Solution: Make sure that the batteries are installed correctly
according to the polarity markings in the battery compartment.
Problem: The red LED is on.
Solution: The batteries are low. Replace the batteries immediately.
9. Cleaning
Wipe the casing regularly with a moist, lint-free cloth. Dry it
immediately with a clean towel. Do not use alcohol or solvents.
These may damage the casing and cause the device to malfunction.
10. Technical Specifications
power supply
sound level
alarm delay
weight
dimensions
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual,
please visit our website www.velleman.eu. The information in
this manual is subject to change without prior notice.
V. 03 – 14/04/2015
HAM200
solar panel
battery
130 dB
exit delay 30 seconds, entry delay 5 seconds
75 g
52 x 82 x 23 mm
4.5 V
3 x 1.5 V AAA batteries (not incl.)
7 ©Velleman nv