Preferences / Vcr - Tech Line DVRC 700 Mode D'emploi

DF-T3712S-SA-W(GB) 2006.9.13 10:0 AM
VPS/PDC
VPS/PDC is a service provided by some stations to enable you to perform
timer recordings precisely even if the broadcaster delays the start time of
the programme slightly. The time you enter is the VPS/PDC time so this
must match exactly the start time of the programme as advertised. NB: Do
not allow 5 mins before the correct start time otherwise the machine will
not record. Not all stations offer VPS/PDC, in which case the player will
start at the time you enter and not the actual start time of the programme.
If you wish to start recording at a specific time without it being adjusted by
the VPS/PDC system in the event of a delay, switch VPS/PDC off otherwise the player will not record.
Follow the same procedure as 'Auto Clock Set' to set the 'VPS/PDC' status.
• "VPS/PDC" and "Auto Clock Set" are not provided for some countries.

Preferences / VCR

This feature enables you to search for Index marks or specific times on your
VHS tapes.
1
Press [SETUP]. The Setup menu appears.
While 'Init Setup' is selected, press [ENTER] to go to the initial setup
page.
2
Use [œ/√] to select 'Preferences
3
While 'Preferences
4
Press [√]. The 'VCR' submenu is displayed.
5
Select 'Index+', 'Index–' or 'Go to Zero'.
If you select 'Index+' (or 'Index–') and press [ENTER], your DVD
Recorder+VCR will locate your index mark and begin playback.
If you select 'Go-To Search' and press [ENTER], your DVD
Recorder+VCR will wind to the position 0:00:00 and stop.
• The VCR menu is activated only when a video cassette tape is inserted.
26
˘ ` 26 mac001
'.
' is selected, press [†] to select 'VCR'.
1200DPI 90LPI
Preferences
Video
Audio
Parental Ctrl
Auto Settings Auto Clock Set
VCR • VPS/PDC
...
œ √ Choose ENTER OK
†
Preferences
Video
Audio
Parental Ctrl
Auto Settings
•VCR Index+
Index-
Go to Zero
œ √ ... Choose ENTER OK
†
Preferences
Video
Audio
Parental Ctrl
Auto Settings
VCR • Index+
Index-
Go to Zero
œ √ ...
Choose ENTER OK
†
Initial Setup
On
Off
SETUP Exit
SETUP Exit
SETUP Exit