Additional Safety Warnings - Batavia MAXX Série Mode D'emploi

English
d. Remove any adjusting key or wrench
before turning the power tool on. A
wrench or a key left attached to a rotat-
ing part of the power tool may result in
personal injury.
e. Do not overreach. Keep proper footing
and balance at all times. This enables
better control of the power tool in unex-
pected situations.
f. Dress properly. Do not wear loose
clothing or jewellery. Keep your hair,
clothing and gloves away from moving
parts. Loose clothes, jewellery or long
hair can be caught in moving parts.
g. If devices are provided for the connec-
tion of dust extraction and collection
facilities, ensure these are connected
and properly used. The use of these
pieces of equipment reduce hazards
caused by dust.
Power tool use and care
2.4
a. Do not force the power tool. Use the
correct power tool for your applica-
tion. The correct power tool will do the
job better and safer at the rate for which
it was designed.
b. Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the
switch is dangerous and must be
repaired.
c. Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands
of untrained users.
d. Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other condi-
tion that may affect the power tools
operation. If damaged, have the power
tool repaired before use. Many acci-
dents are caused by poorly maintained
power tools.
e. Use the power tool, accessories and
tool bits etc., in accordance with these
instructions and in the manner
intended for the particular type of
power tool, taking into account the
6
7063549-Barrel-water-pump-Ma-1712-14.indb 6
working conditions and the work to be
performed. Use of the power tool for
operations different from intended
could result in a hazardous situation.
Service
2.5
a. Please use a qualified expert who uses
original replacement parts to repair
your power tool. This will ensure proper
functioning of the power tool.

3. Additional safety warnings

Please read this manual carefully
and use the unit only according to
this manual.
• Persons and animals must not stand in
the water during operation of the pump!
• Attention! Pollution of the liquid could
occur due to leakage of lubricants.
• The pump has been designed for pump-
ing clear water. The pump is not
intended for delivering salt water, corro-
sive, easily flammable or explosive
liquids (e.g. petrol, paraffin, thinners),
faeces, oil, heating oil or foodstuffs.
• Do not use the pump to deliver solids.
Gravel, sand or the like may damage the
pump.
• Make sure that the temperature of the
water to be delivered must not exceed
35° C.
• Do not operate the pump unsupervised
for long time.
• Do not replace the cord and do not
repair it. It is not allowed to modify the
cord by installing a switch or similar.
• Do not pinch or crimp the cord in any
way. Keep the cord away
• Do not use the cord to carry or trans-
port the pump.
• If not in use, do not hang up the pump
on its cord.
• Protect the pump from frost.
• Do not allow the pump to run dry. Dur-
ing operation always keep the pump
completely immersed in water.
• Remove the battery from the pump if
you clean or do not use it for a long
period of time.
11/04/2019 12:28