WOHLHAUPTER 236 019 Mode D'emploi page 13

To obtain the optimum cutting position,
ensure that the cutting position is in
parallel with the set screw when clamp-
ing the tool holders.
Mini-boring tools (fig. 8)
Secure the mini-boring tools
slide with an adapter
end in the adapter so that the mini-
boring tool reaches its cutting position
and clamp it on the oblique surface with
a threaded taper pin
que 4 Nm/35.4 in.lbs.).
fig. 8
Insert holders for boring (fig. 9)
and outside turning (fig. 10 and 11)
When insert holders
boring or over turning fit the parts speci-
fied in the "clamping elements for insert
q
holders" group
holders are mounted on the K-profile and
secured by using the cap screw
fig. 9
Insert holders for overturning
(fig. 10 and 11)
When tightening the insert holder for
overturning please note the assembly
of 180° off-set.
fig. 10
¸
in the
"
. Apply the shank
¿
(Tightening tor-
1
"
¿
e
are assembled for
in the slide. The insert
w
.
e
w
q
e
w
q
fig. 11
Clamping
The tool is fitted with a clamping screw
2
. The slide
jaws using the clamping screw. This pro-
duces the effect of a vice, so that when
clamping takes place there is no change
in diameter (fig. 12).
¸
fig. 12
When metal-cutting the slide must be
secured using this clamping screw
The clamping arrangement must be ope-
rated before and after each setting pro-
cedure. Graduated dial
ment is located next the tool clamping
point. Only one key is needed to operate
both functions.
To avoid damage to parts of the
adjustment mechanism, do not
make any diameter adjust-
ments in the clamped state.
Diameter adjustment
The matt chrome dial
reading of the diameter setting. The
distance of the adjustment is limited.
Please follow the sequence of operations
for setting the diameter as set out below.
English
3
is clamped between 2
3
2
4
4
for the adjust-
4
gives an exact
e
w
q
2
2
.
13