Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - ALPHA-TOOLS A-SD4,8 V Mode D'emploi D'origine

Anleitung_A_SD_4_8_SPK7:_
GBR
Never allow the battery pack to become fully
discharged. This will cause it to develop a defect.
7.2 ON/OFF changeover switch (Fig. 3/Item 2)
You can select between clockwise and counter-
clockwise rotation.
Change the direction of rotation only when the
equipment is at a standstill. If you fail to observe this
point, the gearing may become damaged.
7.3 LED lamp (Fig. 1/Item 5)
The LED lamp (5) can be used in poor lighting conditions
to illuminate the area where you want to screw. To
switch on, push the switch (6) forwards; to switch off,
pull the switch back again.
7.4 Changing the tool (Fig. 5)
Important!
Insert the bit (A) into the bit chuck (1).
To remove the bit (A), pull it back out of the bit chuck
(1).
7.5 Screwdriving
We recommend using self-centering screws (e.g. Torx
screws, recessed head screws) designed for reliable
working. Be sure to use a bit that matches the screw in
shape and size. Set the torque, as described elsewhere in
these operating instructions, to suit the size of screw.
7.6 Battery capacity indicator (Fig. 4/Item 7)
Press the battery capacity indicator switch (a). The
battery capacity indicator (7) indicates the charge state
of the battery on 3 colored LEDs.
All the LEDs are lit:
The battery is fully charged.
The yellow and red LEDs are lit:
The battery has an adequate remaining charge.
Red LED:
The battery is empty, recharge the battery.
8. Cleaning, maintenance and ordering of
spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
12
17.08.2011 10:44 Uhr Seite 12
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
9. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is between
5 and 30 °C. Store the electric tool in its original
packaging.

10. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material and
can therefore be reused or can be returned to the raw
material system.
The unit and its accessories are made of various types of
material, such as metal and plastic. Defective
components must be disposed of as special waste. Ask
your dealer or your local council.