Functional Description - Makita 3606 Manuel D'instruction

5. Check the bit carefully for cracks or damage
before operation.
damaged bit immediately.
6. Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
7. Hold the tool firmly with both hands.
8. Keep hands away from rotating parts.
9. Make sure the bit is not contacting the
workpiece before the switch is turned on.
10. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could
installed bit.
11. Be careful of the bit rotating direction and the
feed direction.
12. Do not leave the tool running. Operate the tool
only when hand-held.
13. Always switch off and wait for the bit to come
to a complete stop before removing the tool
from workpiece.
14. Do not touch the bit immediately after
operation; it may be extremely hot and could
burn your skin.
15. Do not smear the tool base carelessly with
thinner, gasoline, oil or the like. They may
cause cracks in the tool base.
16. Use bits of the correct shank diameter
suitable for the speed of the tool.
17. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
18. Always use the correct dust mask/respirator
for the material and application you are
working with.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Replace cracked
indicate improperly
or
Symbols
The followings show the symbols used for tool.
･
･
･
･
･
･
･

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Adjusting the depth of cut
003651
Place the tool on a flat surface. Turn the scale ring until
it makes contact with the base. Loosen the clamp screw.
Turn the scale ring until the bit just touches the flat
surface. Tighten the clamp screw.
Place the tool on its side and turn the scale ring
counterclockwise (when viewing the tool from the top)
until the desired depth of cut is obtained. One full turn of
the scale ring is equal to 1/4" change in depth setting.
Loosen the clamp screw and move the tool base until it
makes contact with the scale ring. Then tighten the
clamp screw securely.
CAUTION:
Since excessive cutting may cause overload of the
•
motor or difficulty in controlling the tool, the depth
of cut should not be more than 15 mm (9/16") at a
pass when cutting grooves with a 6 mm (1/4")
diameter bit.
4
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
1. Scale ring
1
2. Clamp screw
2
USD201-2