Functional Description - Makita RF1100 Manuel D'instruction

10. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate improperly
installed bit.
11. Be careful of the bit rotating direction and the
feed direction.
12. Do not leave the tool running. Operate the tool
only when hand-held.
13. Always switch off and wait for the bit to come
to a complete stop before removing the tool
from workpiece.
14. Do not touch the bit immediately after opera-
tion; it may be extremely hot and could burn
your skin.
15. Do not smear the tool base carelessly with
thinner, gasoline, oil or the like. They may
cause cracks in the tool base.
16. Use bits of the correct shank diameter suitable
for the speed of the tool.
17. Some material contains chemicals which may
be toxic. Take caution to prevent dust inhala-
tion and skin contact. Follow material supplier
safety data.
18. Always use the correct dust mask/respirator
for the material and application you are work-
ing with.
SAVE THESE INSTRUCTIONS.
WARNING: DO NOT let comfort or famil-
iarity with product (gained from repeated
use) replace strict adherence to safety
rules for the subject product. MISUSE or
failure to follow the safety rules stated in
this instruction manual may cause serious
personal injury.
Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
revolutions or reciprocation per minute

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and unplugged
before adjusting or checking function on the tool.
Adjusting the depth of cut
1
5
► 1. Motor unit housing 2. Index line 3. Scale ring
4. Graduation 5. Lock lever
Place the tool on a flat wood surface. Open the lock
lever. Turn the motor unit until the bit just touches the
flat surface. Close the lock lever.
Rotate the scale ring until the zero-line is on the index line on the
motor unit. One graduation on the scale ring means the cutting
edge of the bit is exposed 1/64" below the base. While holding
up the base slightly, open the lock lever and turn the motor unit
clockwise until the index line on the motor unit reaches the desired
depth indicated on the scale ring. Close the lock lever firmly.
Switch action
For RF1100 and RF1101
► 1. Switch lever
CAUTION:
• Before plugging in the tool, always check to see
that the tool is switched off.
• Switch can be locked in "ON" position for ease
of operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
4 ENGLISH
1 2
1
ON
OFF
2
3
4