Active / Passive Configuration (Ps15 Only) - Nexo PS Série Manuel D'utilisation

___________________________________________________________________________________________________
« Stage Monitor » Configuration

Active / Passive configuration (PS15 Only)

Switching from passive (factory setting) to active requires the use of the NX242 Digital TDcontroller and
modifications to the PS15 cabinet.
Unscrew the PS15connector plate at the rear of the cabinet (TORX 20 or Allen 2.5) and rotate the 6-pole
connector through 180° from socket « P » to socket « A ». Replace the connector plate, taking care to
remove the plastic blanking plug in the 2 WAY Active Speakon connector. It is strongly recommended to
blank off the two PASSIVE Speakon connectors with blanking plugs to prevent any cabling errors at a
later stage.
See also « Speaker Wiring » section page 6.
PS SERIES MANUAL REV3 10/10/05
LOUDSPEAKERS
100˚
50˚
For stage monitors the required coverage
is always wider when performers are
close to the wedge (above the horn axis)
than when they move away from it (below
the horn axis). For floor monitor use the
horn must be rotated with its "wide"
dispersion side directed towards the top
of the cabinet (as shown by the arrow) in
wedge position as shown in the above
figure. The specific dispersion pattern, the
2" driver and the very high power handling
all contribute to the
performance of the PS15 as a wedge
monitor.
P.9
exceptional