Next Systems CTR50 Manuel D'emploi page 35

ENGLISH
Automatic Setting of the work times
Make sure the gate is completely opened. If not, position it manually. Position the trimmer RV1 to half race and then press once the key P2. After a
few seconds the gate will perform a series of operations which will allow the equipment to automatically learn the work times.
Attention : during the operations of the work times auto-learning all the safety devices are ignored.
Manual Setting of the work times
Make sure the gate is completely closed. If not, position it manually. Press push-button P2 until the led DL1 goes off (about 10 seconds). After a few
seconds the gate starts opening at a reduced speed. During this phase adjust the speed by means of the trimmer RV1 to obtain the desired
slow-down. After 3 seconds from the complete opening, push the P2 key again and wait for the led DL1 and the blinker to go on with a fixed light.
Then push the P2 key repeatedly (6 times) to program the following operations :
1) motor M1 start
2) motor M2 start (delayed)
3) motor M1 slow-down start
4) motor M2 slow-down start
5) motor M1 stop (after 5 seconds from the end of the run)
6) motor M2 stop (after 5 seconds from the end of the run) - end of programming
Attention : during the work times programming all the safety devices are ignored.
Setting the pause time
Press push-button P3 until the led DL1 lights. Let the desired pause time pass, then press push-button P3 again.
35