Next Systems CTR50 Manuel D'emploi page 24

DL6 – Photo-cell led (yellow)
It signals the optical barrier's state. The led goes off when the photo-cell is covered by persons or vehicles
DL7 – Photostop led (yellow)
It signals the optical barrier's state. The led goes off when the photo-cell is covered by persons or vehicles.
DL8 - Opening limit switch led (yellow)
It signals the opening limit switch state for Motor 1. The led goes off when the opening limit switch is operated.
DL9 - Closing limit switch led (yellow)
It signals the closing limit switch state for Motor 1. The led goes off when the closing limit switch is operated.
DL10 - Opening limit switch led (yellow)
It signals the opening limit switch state for Motor 2. The led goes off when the opening limit switch is operated.
DL11 - Closing limit switch led (yellow)
It signals the closing limit switch state for Motor 2. The led goes off when the closing limit switch is operated.
7) Definitions of Trimmers
RV1 – Slow-down speed
It defines the gate's speed during the slow-down phase.
8) Definitions of Dip Switches and Jumpers (Selection of Programs)
Dip switch 1 (Attention: if you place the Dip switch 1 in ON, the state of the Dip switch 2 doesn't have any influence anymore)
It chooses whether the unit will operate in the mode determined by dip-switch 2 or in condominium mode.
ON= Codominium OFF= No effect
Dip switch 2
It chooses whether the unit will operate in step-by-step mode or in automatic mode.
ON = Automatic OFF= Step by step
Dip switch 3
It enables the operation with a single-wing or sliding gate.
ON= Single wing OFF= Double wing
Dip switch 4
It enables or excludes the kickback (during the opening phase with closed gate) and extra-push (during the closure phase)
procedures.
ON= Kickback enabled OFF= No effect
Dip switch 5 (Important: if you place the Dip switch 5 in ON, the Dip switch 3 must be positioned obligatorily in OFF)
It enables or excludes the delay between the wings' starts
ON= 0 sec Delay OFF= Delay enabled
Dip switch 6
It determines the operation of the output 9-10 on the connector J1.
ON= Open gate lamp OFF= Electric lock
24
ENGLISH