Electrical And Mechanical Specifications; Electric Connections - Next Systems CTR50 Manuel D'emploi

ENGLISH
Pedestrian start: The pedestrian start command operates in the same way as the other start command, but in this case only the (M2) wing fitted with
the electric lock will be opened or closed. The pedestrian start command has no effect during a start cycle and up to the end of the closing phase
(closed gate). During a pedestrian start cycle the start command is always active and causes the start of an opening cycle for both wings.

13) Electrical and mechanical specifications

Dimensions and weight (with plastic box) : 186 x 283 x 112 mm - 2,3 Kg
Power supply transformer : 230/12-15-20 Vac - 100VA
Battery-charger capacity : 0,5 A max
Optional battery capacity : 12/24 Vdc – 7 Ah
Blinker power supply : 12/24 Vdc - 15 W max
Relays contacts capacity : 20 A max
Electric lock power supply : 12/24 Vdc - 15 W max
Motor power supply : 12/24 Vdc - 100 W max (total)
Radio receiver power supply (J6) : 12 Vdc - 2 W max
Accessories power supply : 13,5Vdc or 24Vdc - 3 W max
Operating temperature range : 0 to + 60 °C (internal)
nd
2 radio channel relay contact characteristic : 24 Vac - 0,5 A max
Motors' work time : programmable, 1 to 120 sec.
Pause time : programmable, 1 to 120 sec.
nd
2 wing closing delay : programmable, 0 to 120 sec.
Amperometric Stop : Automatic
Caution : The unit must be not switched on if the connected loads or the power supply exceed the a.m. limits. Failure to observe this precaution can
result in damage to persons, animals or objects for which the manufacturer cannot be held responsible.

14) Electric connections

7 electric connectors are fitted to the card :
1) J2 10-pole removable terminal board for the connection of the commands and safety devices
2) J6 10-pole connector for the optional connection of a radio receiver card
3) J5 2-pole Terminal board for the connection of the aerial cable
4) J1 10-pole removable terminal board for the connection of the power devices
5) J3 8-pole removable terminal board for the connection of the limit switches and/or Encoder
6) FS1,FS2 nr. 2 Faston terminal for the connection of a Backup battery
7) FS3,FS4 nr. 2 Faston terminal for connection of the power supply transformer
29