Preventive And Corrective Maintenance; Cleaning And Lubricating; Setting The Cutting Depth - Orgapack CH 43 Mode D'emploi

6
6
5
4
3 2
Fig. 9
2
Fig. 10
10.00/WE
PREVENTIVE AND CORRECTIVE MAINENANCE
1
1

6.1 CLEANING AND LUBRICATING

In the event of severe soiling it is recommen-
ded to clean the tool regularly (daily). The
following parts in particular should be kept clean:
– Punching tools (9/3)
– Tension wheel (9/1)
– Toothed plate (9/2)
This is best performed by blowing out with compres-
sed air (wear goggles).
Apply a few drops of normal machine oil weekly to:
– Eccentric unit (9/6) on sealing lever
– Pressure roll (9/5)
– Bore (9/4) in housing
This will considerably prolong the service life of the
tool and the force required for sealing is also substan-
tially reduced.

6.2 SETTING THE CUTTING DEPTH

The setting of the cutting depth must corre-
spond to the thickness of the relevant strap.
If set incorrectly, the sealing strength can be reduced.
– Release locknut 10/1).
– Set adjusting screw (10/2) with screwdriver.
Turning adjusting screw clockwise increases cutting
depth.
Turning adjusting screw anticlockwise decreases
cutting depth.
Set cutting depth so that the lower strap is not
touched during cutting.
– Tighten locknut.
ORGAPACK CH 43
21