Orgapack CH 43 Mode D'emploi page 20

ORGAPACK CH 43
Releasing strap tension
In order to release the strap again during the
tensioning process:
– Press black tension pawl (5/2) against tensioning
lever (5/1).
– Draw back tensioning lever firmly to disengage the
tension pawls and release the strap tension.
– When the strap tension is reached, move sealing
lever (6/1) to the stop. The right hand remains on
the tensioning lever to resist the opposing force.
The strap is sealed and cut.
– Return sealing lever to initial position.
– Raise the rocker lever against the sealing lever.
– Swivel the tool away from the strapping to the right
at the rear.
Check of seal
To obtain the maximum seal efficiency, the notches
(Fig. 8) have to be cut (interlock) properly into the straps
(check regulary). If these notches are not correctely cut,
replace die and die plate (see chapter 6.6).
20
2
Fig. 5
1
Fig. 6
Fig. 7
Fig. 8
1
1 mm (.039")
10.00/WE