Preventive And Corrective Maintenance; Changing The Battery; Adjusting Welding Time - Orgapack OR-T 50 Mode D'emploi Et De Sécurité

ORGAPACK OR-T 50
7

7.1 CHANGING THE BATTERY

Continuous red light
– Open bow spring and remove discharged battery.
– Insert charged battery and lock with bow spring.
When changing the battery, the new battery
must only be inserted after approx. fi ve
seconds to ensure that the electronic system can
reset to the initial position. If the battery change is too
rapid, the red signal lamp lights up and the unit remains
blocked.

7.2 ADJUSTING WELDING TIME

– The welding time can be infi nitely adjusted with a
screwdriver (no 1), depending on strap quality and
dimension.
– By turning the screw carefully clockwise, the welding
time will be longer, by turning counterclockwise it
will be shorter.
The printed circuit board could be damaged if
the screw is turned too far either clockwise or
anticlockwise.
Check appearance of seal (see fi g. 14)
regularly.
1 Good seal (the complete surface is cleanly welded
without excess material being forced out sideways).
2 Poorly welded seal (not welded over the complete
surface), welding time too short.
3 Poorly welded seal (excess material is forced out
sideways), welding time too long.
An incorrectly welded strapping cannot
secure the package and can thus lead to
injuries.
Never transport or move packaged
goods with incorrectly welded seals.
22

PREVENTIVE AND CORRECTIVE MAINTENANCE

If the red signal lamp (12/1)
is lit continuously, the battery
must be charged (see
chapter 5.2).
Fig. 12
Fig. 13
2
Polypropylen (PP) / Polyester (PET)
Fig. 14
1
1
3
02.08/WE