Hilti TE 2000-AVR Mode D'emploi page 12

4.1.1 Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
Recommended minimum conductor cross-section and maximum power-cord length for 120V supply
voltage
Cord
Conductor cross-section
Conductor cross-section
Cord length
Cord length
5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Fitting the accessory tool
1. Unplug the supply cord from the power outlet.
2. Lightly grease the connection end of the accessory tool.
➥ Use only the recommended grease supplied by Hilti. Using the wrong grease can result in damage
to the tool.
3. Push the accessory tool into the chuck as far as it will go, turning it and applying light pressure until it
engages with an audible click.
4. Check that the chisel has engaged correctly by gripping and pulling it.
5.1.2 Removing the accessory tool
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
1. Unplug the supply cord from the power outlet.
2. Pull the accessory tool retaining bar back as far as it will go.
3. Remove the accessory tool.
6 English
AWG 16
1,31 mm²
2,58 kcmil
25 m
75 ft
3
4
AWG 14 AWG 12
2,08 mm² 3,31 mm²
4,11 kcmil 6,53 kcmil
30 m 50 m
100 ft 150 ft
2167141
*2167141*
AWG 10
5,26 mm²
10,4 kcmil
100 m
250 ft