For Your Safety; Proper Use - Würth Easy Finder Traduction Des Instructions De Service D'origine

GB
Please read and comply with these instructions prior to the initial
operation of your appliance. Retain these instruction manual for future
reference or for subsequent possessors.
WARNING - Hazard electrical shock, not intended for use on
energized wiring or circuits. To avoid electrical shock, disconnect all
sources of elected current before testing (except on line to test).
If you are unfamiliar with logical wiring, consult a qualified electrician or other
professional. Check local codes and requirements before working on electrical or
communication wiring circuits.
In case you do not adhere to this instruction manual, this may result in damage on
the appliance and cause dangerous situations for the operator and other people.
In case of transport damage inform vendor immediately.
The tool is intended for use in applications as described in the operating instruction
only. Any other form of usage is not permitted and can lead to accidents or destruction
of the device. Any misuse will result in the expiry of all guarantee and warranty claims
on the part of the operator against the manufacturer.
The user is liable for damage resulting from improper use.
The PROBE is a receiver and amplifier that detects tracing signals from senders like the
EasyFinder and makes them audible over the built-in speaker. The green signal level LED
lights when the key 1 kHz tone from EasyFinder is detected among the signals on line. Inter-
fering signals such as 50 Hz power hum and its harmonics will not trigger the green LED.
A flashlight function with a pure white light allows the identifying colors of the wires to be
seen clearly in dark distribution boxes. The test tip of the PROBE consists of fiber-reinforced
conductive plastic with a secure bayonet lock that allows easy on-site exchange without
opening the unit.
The Probe is turned on by pressing the High or Low buttons. The High position is the most
sensitive level for tracing weak signals. Low position is used to identify the specific pair or
wire needed.
14

For your safety

Proper use

Probe (Non-contact tone receiver)